Text Box:                                                                                                                                                                                                                 

                                                                                                                                                                                 
                               

 

 

 

 

 

 

 

 

Text Box: CONTACTSText Box: HOMEText Box: ABOUT US
 
 
SPECIFICATIONS

 

KG510  SPECIFICATIONS

---

SPECIFICATIONS

KG510 BASE STATION / REPEATER

GENERAL

Frequency Range

30 MHz Band

80 MHz Band

VHF Band

200 MHz Band

UHF Band

KG510-xxx 50K

Designated 03

Designated 08

Designated 15

Designated 20

Designated 40

Band Splits

 

A:  29.5 - 35 MHz

    B:  35 - 42 MHz

    C:  42 - 50 MHz*

     * Special Order

A:  66 - 78 MHz

B:  74 - 88 MHz

A:  136-156 MHz

B:  150-174 MHz

A:  176-204MHz

B:  200-230 MHz

C:  225-255 MHz

D:  250-280 MHz

SA: 300-335 MHz

  A: 335-370 MHz

  B: 365-400 MHz

  C: 400-435 MHz

DS:420-455 MHz

   D:440-475 MHz

   E:465-500 MHz

   F:485-520 MHz

Number of Channels 

99 channels with channel name

Channel Spacing

12.5, 20, 25, 30 kHz programmable by channel

Mode of Operation

Simplex, Semi duplex, Full Duplex, Repeater

Antenna Impedance

50 Ohms unbalanced

Power Supply

13.6 V DC negative ground, regulated, 10A

Environmental Conditions

TX:  4 A @ 10 W, 6 A @ 25 W, 9 @ 50 W,

RX:  340 mA standby, 370mA receive-mid volume, 525 mA receive-max volume

Dimensions

462 mm (18.2”) wide, 88 mm (3.47”) high, 360 mm 14.2”) deep

Weight

11 kg  (24.2 lb)

Construction

Die cast aluminum chassis and control panel, stamped aluminum bottom cover

Color

Panel, light gray, Chassis dark gray

Front Panel

Volume, squelch, keypad, ext. spkr./headphone jack, On/Off switch, speaker

high and low power adjust, channel select, scan, monitor, shift.

Display, full dot matrix

Operation mode, alarm, busy, channel number, channel frequencies and tones.

Diagnostics

Receive signal strength, transmit power output, alarms for SWR, low PA power, PLL unlock EROM data error

TRANSMITTER

RF Power Output

High power  50 W,   low power  25 W

High/Low Power is programmable by channel and selectable at front panel

Low power level is adjustable down to 1W.

Max. Frequency Deviation

Wide band: +/- 5 kHz,   Narrow band,  +/- 2.5 kHz

Frequency Stability

+0.0002%

Frequency Response

Within +1, -3dB of 6 dB/octave pre-emphasis from 300 to 3000 Hz, 1 kHz ref.

Signal to Noise Ratio

Wide band:  more than 50dB at 1 kHz 70% modulation

Narrow band:  more than 45 dB at 1 kHz 70% modulation

Modulation Distortion

Less than 3% at 1kHz 70% modulation

Spurious and Harmonics

.25 mW or less

RECEIVER

Intermediate Frequency

1st IF: 21.6, 30 MHz band, 48.5 MHz other bands        2nd IF:  455 kHz

Frequency Stability

+0.0002%

Sensitivity

Less than 0.4 mV for 20 dB quieting,

Less than 0.3mV for 12 dB SINAD

Squelch Sensitivity

Less than 0.25 mV

Selectivity

More than 70 dB at 25 kHz point

Blocking

More than 90 dB

Intermodulation

More than 70 dB

Spurious Response

More than 70 dB

AF Response

Within +1, -3 dB of 6 dB/octave de-emphasis from .3 to 3 kHz, 1 kHz Ref.

AF Output

Internal speaker: 3 W @ < 5% distortion into 8 Ohms, 1 kHz

External Speaker: 5 W @ <5% distortion into 4 Ohms, 1 kHz

Signal to Noise Ratio

Wide band, 25 kHz:  more than 50 dB at 1 kHz 70% modulation

Narrow band, 12.5 kHz:  more than 45 dB at  1kHz 70% modulation

NOTICE:

Due to constant  technological developments and changes, specifications may vary without notice.  Options and specifications may vary slightly in different countries to suit local requirements.  Some bands may not be available in the U.S. pending FCC approvals.

 

NEXT  HOME

---

Copyright © 2002 Kyodo Communications & Electronics Inc.